Capacity
All power take-offs are specifically designed for generating hydraulic pumps to SAE J744C series ‘B’ specification with splined insight shaft and either two-bolt or four-bolt fixing. The utmost power which can be transmitted is usually 22 KW (29.5 bhp) per 1000 rev/min engine speed; this compatible a torque of 209 Nm (155 Ibf.ft. – 21.33 kgm.).For PRM1000 the clutched power take-off provides pump rotation exactly like the engine, where as the direct drive power take-off for the PRM500 and PRM750 will give opposite rotation. Power to the pump is not affected by the normal use of the gearbox for propulsion responsibilities. All ancillary power circuits driven by PRM power take-offs should be designed relative to the recommendations of the hydraulic equipment manufacturer, and should be properly safeguarded against overloading.
Installation
PRM power take-off models fit on the rear face of the primary gearcase and are driven by the insight shaft; consequently they could be operated at all times whilst the engine is running, The power take-off replaces the end cover which is normally fitted and performs the features of the end cover by sealing the gearbox against loss of oil and properly positions the insight shaft back bearing. Power take-off products provide the link between the gearbox and the hydraulic pump.
Direct Drive Power Take-Off
Available on the PRM500 and PRM 750 the immediate drive power take-off can be driven directly from the gearbox insight shaft; consequently it’ll operate at all times when the engine is 
usually operating, and since there is no clutch for disengagement of the hydraulic pump, provision must be manufactured in the auxiliary hydraulics circuits for pressure by-pass to the reservoir when power to the pump is not needed. A pair of 1:1 ratio gears, providing enough offset between the gearbox output shaft and the centreline of the power take-off to ensure there is enough clearance between the hydraulic pump and propeller shaft coupling.
Specifications
Ever-Power PTO Shaft
Series 6
1-3/8 inch 6-spline tractor end yoke and a 1-3/8 inch 6-spline FD2 clutch on the implement end
FD2 clutch
Collapsed length: 47 in.
Prolonged length: 60 in.
62 HP at 540 RPM
98 HP at 1000 RPM
FD2 clutch attaches with one bolt that fits a groove on input shaft of rotary mower
If you have any kind of inquiries regarding PTO gearbox call us on our internet site